Finisher Medal Hanger V2

The word only means something because DNF exists

Every runner with a long enough history has one race they did not complete. An injury at 28 km, a cut-off missed by four minutes, a day when the body simply refused. That is the reason the medals matter — finishing was never guaranteed.

This is the second of the two Finisher cuts, with finer lettering than the first. It suits a smaller wall in a room rather than a hallway, and it is the one people choose when the display is going above a desk.

Between the two, this one photographs better, which matters more than it should — a lot of these end up on social media the day they go up.

This medal holder comes in the widths listed here. For a gift, err wide — nobody has ever complained about too much room.

Size & capacity

Not sure which size?

Same capacities as the first version. Choose by lettering, not by size.

The steel, and why it matters

Every medal display in the range is AISI 304 — the same grade used for kitchen surfaces and marine fittings — at 2.5-3 mm depending on width. It doesn't rust, doesn't chip, and doesn't need looking after.

The bar is continuous. That's the whole difference from a hook rack: hooks give you a fixed count, a rail gives you a length.

Fitting it to the wall

Comes with stainless standoffs, fixings and a paper drilling template. On plasterboard use proper anchors rather than the plugs supplied — a full display is heavier than it looks.

When it fills up

A second unit mounts flush against the first, so the wall still reads as one piece rather than two things hung near each other. The widest version holds up to 110 medals across three rails.

Delivery

Every medal display is cut and finished in our own workshop and dispatched within 3–5 working days. Returns accepted for fourteen days.