Rock N Roll Medal Hanger

For people who train with the volume up

A reasonable proportion of endurance sport happens inside a pair of headphones. There is a specific playlist for the long run, another for the last 5 km, and an argument in every club about whether either should be allowed in races.

This design is for that half of the sport. It sits as well in a home gym as in a hallway, and the steel does not mind either.

Garage gyms and spare rooms swing through wide temperature and humidity ranges. Stainless steel is indifferent to both.

These are the sizes available. If it is a present and you are guessing, guess upwards — a display that is slightly too big still looks right.

Size & capacity

Not sure which size?

Gym walls are shorter than hallway walls. Measure the free run above the rack before choosing.

Made from one sheet, not assembled from parts

The medal holder is laser-cut from a single piece of AISI 304 stainless steel, 2.5-3 mm thick depending on the width. Nothing welded on, nothing to come loose.

Medals hang on a continuous rail rather than individual hooks, so you're limited by the width of the bar and nothing else.

Getting it on the wall

Stainless standoffs, screws, plugs and a paper template are all in the box. Tape the template up, mark two holes, drill, and it is done inside a quarter of an hour.

After the first one is full

They're made to pair. A second unit sits flush against the first and the run reads as a single display. The widest version holds up to 110 medals across three rails.

Getting it to you

This medal holder is made to order in the EU and on its way within 3–5 working days, with fourteen days to send it back if it isn't right.